
SERVICING INSTRUCTIONS
REPLACING PARTS
27
ENSURE THE WICKS ARE ASSEMBLED WITH THE
CUTOUTS AT THE BOTTOM EDGE NEAREST THE
BURNER BASE TO ALIGN WITH THE OIL WAYS. THE
VAPORISING PLUG MUST BE FITTED CORRECTLY AND
THE SHELLS SEATED TO THE BURNER BASE WITH AN
AIR TIGHT SEAL. THE LIGHTING PORT MUST BE
FACING FORWARD.
• FINALLYFITTHELID
NOTE: IF THE COOKER IS BEING SERVICED AS A
WHOLE, DO NOT FIT THE BURNER UNTIL THE FLUE
WAYS HAVE BEEN CLEANED.
3. FLUE WAYS
• RemovetheburnerasdescribedinSection2
• Removethethreescrewsoneachofthehotplates.
• Liftoutbothplates.Theseareveryheavy.
• Removethe“D”bafflefromthebarrelnotingits
orientation
• Cleanallthefluewayswithasuitablebrush
• Reassembleinreverseorderandensurethefinsonthe
boiling plate run parallel with the cooker
• Checkallseals
4. OIL VALVE
• TurnofftheOilSupplyatthetank
• Turnofftheisolationvalveatthecontrol
• RemovetheDrainingScrewfromtheOilControland
drain the oil from the Control
• Removethetwopanheadscrewssecuringthevalve
cover plate
Lift the cover from the Control Knob end. Note the position
of the arm attached to the Lid. It rests on the metering
system.
• Removethetwopanheadscrewssecuringthefilter
compartment cover flange
• Removethenylonfilterelement
• Replacethedrainscrewensuringitsealsonit'ssealing
washer
Carefully clean the slot of the metering stem with a non
metallic instrument. It is of paramount importance that the
size of this slot is not increased. If the slot has been enlarged
this will automatically increase the size of the flow of fuel.
The stem should be cleaned with kerosene. Avoid hand
contact with the area adjacent to the slot as oils on the skin
can partially or wholly block the slot.
• Removethepanheadscrewandcarefullyliftoutthe
Inlet Valve and Float assembly
• CleantheInletValveTipanditsmatingseat
• Reassemblethecomponentscarefully
• Turnontheoilsupplyandallowthevalvetofill
• Checkforleaks
5. COOKER CHECK
• Checkthetopandbottomovenventsarenotblocked
• Checkthedoorsealsaresound
• Checkthehotplatelidsealsaresoundandseated
correctly
6. RECOMMISSIONING
• Ensuretheburnerhasbeencorrectlyassembled,Section
2
• Checkandadjustfluepullifnecessary
• Instructtheuserforcontinuedsafeoperationandto
maintain the guarantee the appliance must be serviced
every six months
• Demonstratethecorrectoperationoftheapplianceand
ensure the customer has a copy of the user instructions
• Advisethecustomerthatundernocircumstancesattempt
to light a hot burner
7. BOOSTING ELEMENT
7.1 The boost oven element is situated in the lower right-hand
oven. To remove the element:
• Undothetwoscrewsholdingthesupportbracket,
Diagram 6, Arrow A
6
AR1560
B
A
A
• Removethesinglefixingscrewholdingtheelementand
carefully pull it forward, Diagram 6, Arrow B.
• Removethetwowiresandreplacetheelement
• Reassembleinreverseorder
Kommentare zu diesen Handbüchern